Industrial Valves for Steel Plants

For the steel industry

Eurad advises and supplies according to your specified requirements the most applicable valve when it means:



COOLING WATER

Controlling cooling water flows: with the choice of the appropriate control valves, the risk of generating cavitation can be reduced. As a result the fault free operation time can be increased and maintenance costs can be reduced.

Blocking cooling water flows: with the choice of the correct block valves the fault free operation time can be increased and the operation costs will be reduced. With an extra feature to block the valve in the closed position it is allowed by the authorities to carry out (maintenance) activities behind the blocked valve with the upstream pipeline under pressure. For underground positioned or high positioned blockvalves Eurad advises in relation to the high assembly and removal costs to choose for the best valve designs.

Prevention backflow of cooling water flows: with the choice of the appropriate check valves, the generation of unacceptable pressure or vacuum peaks due to incorrect check valve closing after a spontaneous pump stop will be avoided. With more pumps parallel running a proper closing of the check valve after a spontaneous pumpstop is of enormous importance to avoid waterhammer.
Our advise is to specify a check valve that follows the decrease in flow immediately and will be closed at Qpositive = 0. If this cannot be reached in your project or by your choice of the check valve, a controlled and quiet closing of the check valve can be achieved by controlling the valve closing by means of an adjustable external mounted hydraulic brake unit. Eurad can advise in this and can supply the optimal functioning check valve.

Avoiding or limiting upsurge pressure or downsurge pressure peaks caused by spontaneous pump stop: besides doing this by the choice of the appropriate check valve it is possible to supply an extra protection against an unacceptable increase in pressure in the pipeline by fitting a pressure reliefvalve in the pipelinesystem. This safety protects the discharge pipeline against an overpressure caused by waterhammer by opening at an overpressure of e.g. 1.2 times the working pressure.
The protection of the discharge pipeline against too deep vacuum conditions can be achieved by installing an appropriate airvalve to supply air into the pipeline. One can choose to supply air into the system only at a certain vacuum value of e.g. minus 3 meters Wc. Eurad has the assistance of a number of waterhammer calculating specialists and can together with them advice accordingly.

Lowering pressure loss by venting air: except cleaning the pipeline and avoiding the entry of air into the system, the decrease in pressure loss in the discharge pipeline can be reached by mounting at the right place and in the correct way sufficient air release valves. We advise air valves venting air continuously under each operating pressure without aerating the system at vacuum conditions. Eurad has access to decades of experience in this application and can give you the best advice.


PROCESS GASES AND PROCESS LIQUIDS

Controlling process gas and process liquid flows: with the choice of the appropriate control valves the risk of generating cavitation can be reduced. Control valves in steam, (hot) wind, cokes gas, blast furnace gas and flare gas are preferably offered with the main shaft bearings positioned after the stuffingbox shaftsealing seen from the center of the valve. Eurad likes to advise.

Blocking of process gas and process liquid flows: the choice of the correct block valves will increase a troublefree operation and can decrease maintenance costs. Valves in steam, (hot) wind, cokes gas, blast furnace gas and flare gas are preferably offered with the main shaft bearings positioned after the stuffingbox sealing seen from the center of the valve. Eurad likes to advise.

Preventing backflow of process gas and process liquid flows: the choice of non-return valves with a short closing stroke and a small mass inertia valve disc can result in a very short closing time. This will be the safest way to avoid medium backflow. Within Eurad we have the knowledge and expertise to offer the appropriate checkvalve.


AN OVERVIEW OF APPLICABLE EURAD INDUSTRIAL VALVES

For use in cooling water:

For application in process gases and fluids such as wind, coke oven gas, blast furnace gas, steam and process water installations: